Shandong Defu supply generator rotor and stator water cooling dedicated plate heat exchanger! Generator rotor and stator water is the generator rotor and stator coil transition energy loss heat out, the rotor and the stator coil temperature is maintained at acceptable temperature, to ensure proper operation. Generator rotor and stator cooling water system - 1. rotor cooling system from the hot water out of the back of the rotor coil rotor 3m3 of water tank, the tank bottom of the rotor, two pipes were connected to two sets of rotor cooling pump inlet, the normal operation of a station, the rotor cooling water pump boosted, to a heat exchanger for cooling (two runs three heat exchanger), the cooling water cooled finally to the rotor coil. There is a supplementary water tank rotor interface, in addition to volume of brine from the system can be manually maintain the tank level. Rotor cooling water failure, you can make the red rotor tanks, drainage, water quality until qualified. Rotor cooling water temperature can be used to manually adjust the water flow through the heat exchanger to be controlled. 2. The stator cooling system from the stator coil and the stator clamping ring back to the hot water flowing out of the stator 5m3 water tank, the water tank filled with 0.01-0.03MPa nitrogen, and oxygen for isolating contact with cooling water, to reduce the corrosion of copper. The stator has two pipes connected to the bottom of the tank with two sets of stator cooling water pump, respectively, out of the water from the tank after a boost stator cooling water pump, three stator flows through the shell side of the heat exchanger in any two units by the sea demineralized water after cooling to the stator coil and stator pressure circle. Leads all the way to 2-5% of the cooling water flows from the stator cooling water outlet, after ion exchange treatment tank back to the stator. Ion exchange is run according to the water quality of interruption. Demineralized water heat exchanger side outlet stator has a three-way pneumatic valve to control the flow through the heat exchanger, and to achieve the stator cooling water temperature control, this valve is automatic. Rotor and stator cooling water temperature control in 30-40 ℃. During normal operation, the rotor cooling water flow 35t / h, the stator coil cooling water flow is 46t / h, pressure ring stator cooling water flow rate of 10 × 2t / h. Stator and rotor cooling water inlet pressure is less than 0.4MPa above is for the generator rotor and stator water cooling Details dedicated plate heat exchanger to provide heat by Wu County Defu device itself, if you supply the generator rotor stator cooling water plate heat exchanger dedicated information have any questions, please make further contact with the company to get more information for the generator rotor and stator water cooling dedicated plate heat exchanger. .